Barco F90 - W13WUXGA, Руководство пользователя

Страница: 44 / 103

4. Physical Installation
1b
2b
3b
Image 4-8
2. Adjust the left side Scheimp fl ug adjustment screw (reference 1) until the test image in the top right side of the screen is in focus.
Use a size 4 hex key to do this.
Note: This process may cause the other areas of the image to slide out of focus. This is totally normal.
1
F
Image 4-9
3. Adjust the right side Scheimp fl ug adjustment screw (reference 2) until the test image in the top left side of the screen is in focus.
Use a size 4 hex key to do this.
Note: This process may cause the other areas of the image to slide out of focus. This is totally normal.
2
F
Image 4-10
4. Adjust the top Scheimp fl ug adjustment screw (reference 3) until the test image in the bottom half of the screen is in focus. Use
a size 4 hex key to do this.
Note: This process may cause the other areas of the image to slide out of focus. This is totally normal.
3
F
Image 4-11
5. Continue adjusting the screws one at a time until the test image is uniformly sharp across all areas of the display.
6. Test the focus by zooming out (minimum image size on screen) and then zooming in again. Verify the image is still sharp. If there
are any deviations to sharpness, repeat steps 2 to 6 until the image is correct.
7. Tighten the three set screws in the following order: left (1b), right (2b) and then top (3b). Use a size 6 hex key to do this.
40 601–426 F70 SERIES 24/10/2017