Barco F90 - W13WUXGA, Руководство пользователя

Страница: 23 / 103

2. Getting to know the projector.
When replacing batteries, the broadcast address of the RCU will be reset to its default value ’0’.
C
AUTION
:
Replace with the correct battery type. Use two AA size batteries. There is a risk of explosion if the
battery is replaced with an incorrect type.
C
AUTION
:
Replace the battery as explained above. There is a risk of explosion if the battery is incorrectly
installed.
2.7.2 Remote control, protocol setup
About the used protocol
The protocol is the code send out by the remote control when a button is pressed. Depending on this code, the projector can decode
the signals. The remote control can be used with two different protocols, RC5 and NEC. Depending on the projector to control the
remote control can be switched between these protocols.
Which protocol to use
• The NEC protocol have to be used for Barco projectors based on the Pulse platform: Loki, Balder, F70, F80, F90, HDX 4K,
UDX, ...
• The RC5 protocol have to be use all other Barco projectors: HDX W, HDF W, HDQ 2K, ...
How to set
1. Remove the cover. For more info on how to remove, see "Remote control, Battery installation", page 18.
2. Place the switch in the NEC position.
Image 2-7
Remark with RC5 protocol
Not all buttons of the Pulse RCU are one-to-one compatible with the legacy Barco RCU. Button pairs SHUTTER open/close and
POWER on/off emit the same code (per pair) when in RC5 mode, because the legacy RCU’s only had 1 button for Shutter and 1
button for Standby.
601–426 F70 SERIES 24/10/2017 19