Installation
E-2320 C
25
•
Put the connector compartment cover back on the display.
Pay attention that the signal cables are positioned under the
bulge in the cover.
•
Push the cables into the clips on the rear of the tilt & swivel
foot.
•
Bind the cables together above and under the foot, by
means of the 2 velcro strips attached to the inside of the foot
cover (packed inside the accessory box).
•
At last, put the foot cover back in place.
To put the foot cover in place:
Figure 11
1. Push the upper side of the cover onto the foot, so that the
hooks inside the cover are positioned right under the bulges
at the rear of the foot.
2. Slide the cover upward while moving the lower side of the
cover towards the foot.
3. Press the cover to the foot so that it makes a clicking sound.
(1)
