Barco DP2K-S Series, Руководство пользователя и инструкция по установке

Страница: 66 / 153

10. Scheimpflug
10.3 Fixation of the Lens Holder front plate
When fi xing the Lens Holder front plate
After performing the procedure for Scheimp fl ug adjustment or Back Focal Length adjustment the Lens Holder front plate must be
secured in such a way that it doesn’t disturb the result of the adjustment.
Necessary tools
• 10mm nut driver.
• 3mm Allen wrench.
• 13mm nut driver.
How to fi x the Lens Holder front plate?
Start the fi xation as follows (steps must be followed strictly) :
1. Project the framing test pattern for FLAT & SCOPE.
2. Zoom the projected image until the edges of the projected test pattern matches with the edges of the projection screen.
FLAT
SCOPE
Image 10-10
3. Turn in the three set screws indicated with reference 11 image 10-11 without disturbing the projected image. Tighten lightly . Do
not turn in the set screw at the lower left of the Lens Holder!
Note: Ensure that the edges of the projected test pattern remain in place on the screen. Any movement of the image will affect
the Scheimp
fl ug adjustment.
4. Fasten the lock nut (reference 21 image 10-11) of the three set screws. Use a 10mm nut driver. Ensure the image doesn’t move.
11
11 21
Image 10-11
5. Gently turn (by hand) the Scheimp fl ug adjustment nut at the lower left of the Lens Holder (reference 4 image 10-12) against the
Lens Holder front plate without disturbing the projected image.
6. Turn in the set screw at the lower left of the Lens Holder (reference 14 image 10-12) without disturbing the projected image. Use
a 3mm Allen wrench.
Note: Ensure that the edges of the projected test pattern remain in place on the screen. Any movement of the image will affect
the Scheimp
fl ug adjustment.
Tip: Fasten the set screw and the Scheimp fl ug nut alternately, without disturbing the projected image, until the Scheimp fl ug
nut and set screw are completely tightened.
62 R5977692 DP2K-S SERIES 10/12/2012