Projector Set Up
5-2 ___________________________________________________________________________ R5975819.05 BARCO CINE 6 21112002
Setting the projector address
The projector's address may be set to any value between 0 and 255. When the address is set, the projector can be controlled
now by
RCU for
addresses between 0 and 9.
Note : A projector will respond to a RCU set to an address of 0 regardless of what address is set in the projector
itself.
Address setting is a software setup of your projector which must be done during installation.
Note : With the address button on the RCU, the projector will display its own address on the screen. Once the
address button is pressed, to continue using your RCU, it is necessary to enter an address with the numeric
keys, even when the address remains the same.
Power up mode :
The projector can start up in two different modes. The start up mode is determined by the software.
1.
Operational mode
:
When the power switch on the back of the projector is pressed, the projector displays the last selected source if available,
otherwise it remains on that source number until the source becomes available.
2.
Stand by mode
:
When the power switch on the back of the projector is pressed, the projector goes into stand-by. The stand-by key on the RCU
or the local keypad is used to turn the projector ON and OFF.
Baud rate for communication with a computer
Computer communication is only available when the optional RS232 communication port is installed.
The communication speed between projector and computer, e.g. PC or MAC, is fixed at 9600 baud rate.
