![background image](http://html1.mh-extra.com/html/barco/cine-5/cine-5_owners-manual_473925018.webp)
Controlling
4 - 2 ___________________________________________________________________________________ R5976101 BARCO CINE 5
How to use the RCU
a.
Point the front of the RCU towards the reflective screen surface.
b.
Point the front of the RCU towards one of the IR sensors in the projector.
When using the RCU, make sure you are within the effective operating distance (10m or 30 ft. in a straight line). The RCU will
not
operate properly if strong light strikes the sensor window or if there are obstacles between the RCU and the projector's IR sensor.
c.
RCU used in a hardwired configuration. Plug one end of the remote cable in the connector at the end of the RCU and
the other end in the connector on the rear panel of the projector labelled 'REMOTE'.
Projector address
a. Software setup of the projector address
See ' Change Projector Address ' in chapter ' Service Mode '.
Every projector requires an individual address between 0 and 255, which is set in the service mode. Only projectors with
addresses between 0 and 9 can be controlled with the RCU.
b. How to control the projector
The projector's address may be set to any value between 0 and 255. When the address is set, the projector can be controlled
with :
- the RCU for addresses between 0 and 9.
- a computer for addresses between 0 and 255.
Note : The projector will respond to a RCU set to an address of 0 regardless of what address is set in the
projector.
c. Using the RCU
Before using the RCU, it is necessary to enter the projector address into the RCU.
The projector with the corresponding address will respond to that RCU.
How to display the projector address.
Press the ADDRESS key (recessed key on the RCU) with a pencil.
The projector's address will be displayed in a 'Text box'.
CEILING
S
C
R
EEN
IR SENSOR
45
o
45
o
45
o
45
o
PROJECTOR
ADDRESS 001