-19 -
How to Install the
LCD Unit
Follow the next steps :
Installation of the MOCA LCD Holder
Necessary Tools
The following tools are necessary to fix the LCD unit into the projector :
·
Flat head screw driver, nutdriver 7 mm.
Be careful not to force
side ways !
On Axis Position Notch
Off Axis Position Notch
LCD Panel Slot Base Chassis Plate
lcd Panel Holder Foot
Illustration 1
Image
Illustration
1
2
3
Action
The LCD unit must be slid into the vacant slot for the LCD panel
and secured in position using the four fixation screws . Before
inserting the LCD unit, look into the free space. On one side of
the base chassis plate two attachment notches are visible, one
for ON-AXIS and one for OFF-AXIS. The foot of the LCD Panel
Holder must latch onto one of the two notches dependent on the
projector setup.
Slide the LCD unit into the slot with the LCD panel facing the fixation
unit. Rest the foot of the LCD holder on the edge of the notch that
it is to be latched upon, then very very gently jiggle the unit to
encourage it to nestle snugly onto the notch.
Align then Attach the four mounting screws loosely.
Recheck for correct positioning on the correct notch by illuminating
with a torch through the space between the LCD panel and the
chassis. If a notch is visible, than the LCD unit is mounted in the
ON-axis position. If the notch is not visible, the unit is in the OFF
axis position. If alignment is correct tighten the four mounting
screws (place a thumb on top of the turnable fixation, so as to
ensure against possible slippage of alignment) securely to the
chassis.
Step
1
2
3
