Barco BarcoReality 909 Split Pack R9040040, Инструкция по эксплуатации

Страница: 29 / 58

Installation setup
4 - 5
5976397 SPLIT PACK REALITY 909 09112001
Scan position check
To check the scan position i.e. the orientation of the scan connectors proceed as follows:
This procedure can only be done after power (mains) connection. So, first continue with the projector setup and the connections
and then return to this procedure.
1 Switch on the projector. The projector starts up on the last selected source.
2 Press ADJUST .
3 Highlight SERVICE by pushing the cursor key é or ê (menu 1).
4 Press ENTER , SERVICE MODE menu will be displayed. (menu 2)
5 Highlight PROJECTOR SET-UP by pushing the cursor key é or ê and press ENTER .
6 Push the cursor key é or ê to highlight IDENTIFICATIOn (menu 3).
7 Press ENTER to select.
The identification screen will be displayed (menu 4).
This screen gives the current information about the projector configuration in the line entitled CONFIG.
Proj. address : 001
Soft. Version : 2.11
Config. : Ceiling
Front
Baudrate PC : 9600
Text : ON
Serial No. : 1035895
REALITY 909
menu 3
menu 4
Select with é or ê
then <ENTER>
<EXIT> to return.
SERVICE MODE
PROJECTOR SET-UP
MEMORY MANAGEMENT
COMMON SETTINGS
I2C DIAGNOSTICS
VOLTAGE DIAGNOSTICS
PROJECTOR DIAGNOSTICS
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
PROJECTOR WARM UP
POWER UP MODE : operating
COMMON ADDRESS : 0
Select with é or ê
then <ENTER>
<EXIT> to return.
ADJUSTMENT MODE
Select with é or ê
then <ENTER>
<EXIT> to return.
Select a path from
below :
RANDOM ACCESS
INSTALLATION
SERVICE
menu 2
All projectors leave the factory set with a ceiling/front configuration.
menu 1 menu 3