Barco BarcoReality 908, Руководство по установке

Страница: 28 / 74

4. Installation Setup
Connecting the cable tube to the optical block
The cable tube contains 6 cables, each with his own connector. Make sure to connect the side with the longest EHT cable to the
optical block. There is an opening to mount the cable tube in on the right and left side of the block. The unused opening is closed
with a protection plate.
1. Loosen the fastener ring on the side off the cable tube with the longest EHT cable. (image 4-8)
2. Put the cable tube connector through the opening, the cable tube can be connected on the right or the left side (image 4-9)
3. Tighten the fastener ring so that the cable tube is secured to the block. (image 4-10)
4. Put the EHT cable through the opening at the back of the optical block, inside the projector make sure to guide the cable UNDER
the picture tube unit and connect this cable to the EHT connection on the EHT block. (image 4-11)
5. Connect the RGB cables to the BNC connectors on the back of the optical block , the cables and connectors are marked with
their respective colors. (image 4-12)
6. Connect the Signal and Data cables to the corresponding connectors on the back of the optical block. Interchanging of the two
36 pin connectors is prevented by a build_in key in the female connectors. (When these cables need to be unplugged, push the
tabs on the sides of the connector and pull backwards) (image 4-13)
7. Put the protection plates back in place.
Image 4-8
Loosen the fastener ring on the side off the cable tube with the longest
EHT cable
1 EHT connector (longest cable) to Optical Block
1’ EHT connector (shortest cable) to Electronic Block
2 RGB BNC connectors
3 Signal/Data connectors
Image 4-9
Put the cable tube connector through the opening
22 R5976354 BARCOREALITY 908 SPLIT PACK 10092002