Barco BarcoReality 908, Руководство по установке

Страница: 30 / 74

4. Installation Setup
Image 4-13
Connecting the Data and Signal cables
J1 36 pin connector with white wires
J2 36 pin connector with green wires
J3 24 pin connector with grey wires
Connecting the cable tube to the electronic block
1. Loosen the fastener ring on the cable tube. (image 4-14)
2. Put the cable tube connector through the opening, the cable tube can be connected on the right or the left side. (image 4-15)
3. Tighten the fastener ring so that the cable tube is secured to the block. (image 4-16)
4. Connect the EHT cable to the EHT connection on the back of the electric block. (image 4-17)
5. Connect the RGB cables to the BNC connectors on the back of the electric block, the cables and connectors are marked with
their respective colors. (image 4-18)
6. Connect the Signal and Data cables to the corresponding connectors on the back of the electric block. (image 4-19)
7. Put the protection plate back in place.
Image 4-14
Loosen the fastener ring on the cable tube
1 EHT connector (longest cable) to Optical Block
1’ EHT connector (shortest cable) to Electronic Block
2 RGB BNC connectors
3 Signal/Data connectors
24 R5976354 BARCOREALITY 908 SPLIT PACK 10092002