barbas ECO 60, Инструкции по использованию / Установке

Страница: 80 / 84

80
ECO 60 / 70 / 90 / 100
The wood burns up too quickly. What should I do?
Ensure that air cannot get in underneath the fuel. Move the combustion air
supply slider towards th e “
-
” position. (The pr imary air supply is now closed.)
Under these conditions, the layer of ash should no longer burn bright orange/
white but red.
If there is a draught (due to strong wind), air intended as secondary air for above
the fuel may enter through the openings above the door and flow straight down
beneath the wood. Also slide the combustion air supply slider tighter shut.
There may be too much of a draught in your chimney, particularly if it is very high
(in excess of 8 m). Ask your supplier to fit a check valve or damper. This may not
be possible in all cases.
Can I leave my stove unattended?
Only do this when the appliance is burning quietly, with just a little wood, with
a closed door and with the combustion air supply slider in the centre position
between “ + ” and “ - ”. In this position, the primary air supply beneath the grate
is closed and the secondary/tertiary air supply is open. Secondary air is supplied
through the small holes in the rear panel of the combustion chamber. Tertiary air
is supplied through the opening behind the glass at the top of the combustion
chamber.
Do not leave children unattended while the stove is burning .
Do I have to take any extra measures if the room I am heating has an
extractor fan (mechanical ventilation)?
If the combustion air comes from the living-room :
A flue gas fan is required when there is permanent extraction of the area in
which the fire is placed.
The type of flue gas fan depends on the capacity of the extractor system.
Always consult your installation engineer about this.
If the combustion air comes directly from outside via a direct connection :
If there is constant extraction of the room in which the fire is located, no
additional provisions are necessary.