Baoli CPCD 80, Инструкция по эксплуатации и обслуживанию

Страница: 18 / 112

12
(15) The starting, turning, driving, braking and stopping of the truck should be done
smoothly. When turning on the humid or slippery road, the truck should be decelerated.
(16) Because the forklift truck turns by the rear wheels, the end counterweight may
swing widely when turning. Use care in narrow aisles and other workplaces.
(17) Operate the forklift truck smoothly, don’t jerk the steering wheel. Avoid sudden
stop, acceleration, stop or turn. In the case of improper operation, the truck will turn over.
In case of this, the driver must keep calm, don’t jump off the truck. The driver must hold
tightly the control wheel with two hands; meanwhile, his body must incline in opposite
direction of truck’s turning over.
(18) Turning, lateral or deflective traveling shall not be taken on a slope. It could
cause overturning of the truck, it is very dangerous. On a slope, drive the truck with load
forward to ascend and backward to descend. When the truck goes down on a slope,
drive slowly with the brakes on. Make sure that the engine should not be shut down
when traveling on a slope.
(19) The stability of the truck is influenced by the wind-force during outside
operation, you must notice specially.
(20) Be careful and slow driving over a dock or temporary paving slab.
(21) Insert forks deeply under goods. Adjust fork’s distance according to the
dimension of goods. Make the loads distribute on the forks evenly to avoid tilt and slide
of goods.
(22) Don’t pick the loads with single fork. Fork can not be used to pull out any
embedded goods, if necessary, the pulling force should be estimated.
(23) Don’t handle unfixed or loose goods. Be careful to handle bulky goods. To
prevent the collapse of stacked goods, tighten them. Forbid loading loose or little
volume goods without pallet.
(24) When loading the goods, lower the forks to the floor. After the fork inserting
stacked goods, the fork arms should be in contact with the goods. Drive the truck with
mast tilting back for stabilizing the load. Before traveling, raise the forks for
200mm-300mm from the floor.
(25) When handling bulky loads which block your view, operate the forklift truck in
reverse or have a guide.
(26) While mast’s lifting and lowering, anyone is absolutely prohibited from standing
under the lift bracket or being lifted with forks. Never permit anyone to stand or walk