Baoli CPCD 80, Инструкция по эксплуатации и обслуживанию

Страница: 12 / 112

6
etc.
(6) Check for all the terminals and plugs in normal state. Check the meters, lamps,
switches and electric circuit if they are running properly.
(7) Check every pedal for free stroke and the levers for looseness and smooth
operation. Check lifting system, actuate the lifting and tilting levers to be certain that the
lift bracket moves up and down properly and the mast can be tilted smoothly. Check
brake system and steering system for flexibility and reliability.
(8) Check the wheel brake: the free stroke of brake pedal is 4-8 mm, when
achieving effective brake, the clearance between the front floor and the pedal should be
more than 20mm.
(9) Check the parking brake: the unload forklift truck can park on 20% slope, when
the parking brake is locked.
(10) Check all connectors and fasteners for looseness.
3. Start and stop of the engine
(1) Start of the engine
(a) First set the shift lever at the neutral position and the parking brake at the
braking position.
(b) When starting, put the key into the start switch, turn it in the counter clockwise,
preheat 15-20
seconds, and then turn it in the clockwise to “START” so the starting
motor works. When your hand is away from the k
ey, it automatically returns to “ON” by
spring force. Every starting time shouldn’t morn than 15 seconds. Restarting should be
after 30 seconds. As the engine doesn’t work after some times starting, should check
and remove the trouble, do not keep the starting motor engaged for a long time .
(c) Following the start of the engine, it’s necessary to set the engine on idle running
for five minutes. Full load operation can’t be started until water temperature of the
engine rises above 60
℃
.
When the engine is on idle running, you must check water thermometer, oil
manometer, ammeter, fuel measurer, and so on for the data, whether to meet the
specification, and check each pedal for free stoke, braking performance for its reliability,
steering operation for its flexibility, tyre pressure for its conformance to the standard. If
there is no trouble, operation may be allowed.