DOscan10
Overview
Thank you for selecting the DOscan10 dissolved oxygen tester. This manual provides a step-by-step guide to help you operate the instrument,
please carefully read the following instructions before use.
Installing the Batteries
1.
Twist the connector collar counter clockwise, pull the 6-pin connector away from the tester.
2.
Insert the two AAA batteries into the battery compartment, note polarity.
3.
Push the 6-pin connector into the tester and twist the connector collar clockwise until tight.
Keypad
Key
Function
• Switch the tester on or off
• Lock the reading, press the key again to resume measurement
• Exit the calibration, setting and return to the measurement mode
• Start calibration
• Press and hold
the key to enter the setup menu
• Select an option
• Confirm the calibration, setting or displayed option
Display
Icon
Description
When the battery voltage falls below the minimum power requirements, the icon automatically disappears
MEAS
Indicates that the tester is in the measurement mode
CAL
Indicates that the tester is in the calibration mode
SETUP
Indicates that the tester is in the setup mode
ATC
Indicates that the temperature compensation is enabled
Prior to Use
Take out the dissolved oxygen electrode from carrying case. Insert the 6-pin connector into the connector socket on tester, make sure that the
connector is fully seated.
