Bante520 Portable Conductivity Meter
5
Switching the Meter On and Off
•
Press the
Meas
key to switch on the meter, the display shows the measured value.
•
Press and hold the
Meas
key for 5 seconds, the meter will switch off.
To enable the Auto-Power Off feature, please refer to chapter SETUP MENU.
Setup Menu
The Bante520 portable conductivity meter contains an integrated setup menu that is used to customize the displayed option to meet measurement
requirements. The following table describes the functions of the menu items.
MENU
DESCRIPTION
OPTIONS
DESCRIPTION
DEFAULT
Set the cell constant to match connected electrode.
K=0.1
K=1
K=1
K=10
Set the number of calibration points.
1 point
3 points
2 points
3 points
Set the temperature correction method and coefficient.
Linear (Range: 0.0~10.0%/° C)
Linear
2.1%/° C
Non-linear
If enabled, pure water coefficient will be applied
automatically for ultra-pure water measurements.
Enable
Disable
Disable
Set the normalization temperature for measurement
and calibration.
25° C
25° C
20° C
Set the default temperature unit.
Degrees Celsius
° C
Degrees Fahrenheit
If enabled, the meter will automatically sense a
stable reading and lock the measurements.
Enable
Disable
Disable
If enabled, the meter will automatically turn off
if no key is pressed within 30 minutes.
Enable
Disable
Disable
Delete all stored readings in the memory.
Enable
Disable
Disable
If enabled, all of the calibration data and selected
parameters will back to factory default settings,
the meter must be recalibrated.
Enable
Disable
Disable
The meter contains two temperature correction methods. The linear temperature correction is appropriate for most samples. If the current sample is
belong to the natural water (e.g., natural ground, well, or surface waters), using the non-linear correction is necessary. Note: non-linear correction
can only be performed at temperature range from 0° C to 36° C. If the temperature value is out of above range, the meter will always show
“
----".
