Bante520 Portable Conductivity Meter
4
Installing the Batteries
•
Remove the battery cover from backside of the meter.
•
Insert three AA batteries into the battery compartment, note polarity.
•
Replace the battery cover into its original position. Installation is completed.
When the batteries are depleted, the meter allows using the DC5V power adapter with USB cable for power supply. NOTE, take out the batteries.
Connecting the Sensors
•
Take out the conductivity electrode from the packaging. Insert the 6-pin connector into the connector socket on meter. Ensure the connector is fully
seated. After connection is completed, DO NOT pull on the sensor cord. Always make sure that the connector is clean and dry.
•
Insert the connector of temperature probe into to the corresponding connector socket.
Prior to Use
Soak the conductivity electrode for a few minutes in tap water to remove dirt and oil stains on the electrode.
