Safety and Compliance Notices
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to
serious injury or death. This device does not include the self-checking redundant circuitry necessary
to allow its use in personnel safety applications. A sensor failure or malfunction can cause either an
energized or de-energized sensor output condition.
Laser Safety
The following information is provided to comply with the rules imposed by international authorities and refers to the
correct use of the TCNM-AD/EX family of scanners.
Standard Regulations
This scanner uses a low-power laser diode. Although staring directly at the laser beam momentarily causes no known
biological damage, avoid staring at the beam as one would with any very strong light source, such as the sun. Avoid
allowing the laser beam to hit the eye of an observer, even through reflective surfaces such as mirrors, etc.
This product conforms to the applicable requirements of IEC 60825-1 and complies with 21 CFR 1040.10 except for
deviations pursuant to Laser Notice N° 50, date June 24, 2007. The scanner is classified as a Class 2 laser product
according to IEC 60825-1 regulations.
There is a safety device, which allows the laser to be switched on only if the motor is rotating above the threshold for its
correct scanning speed.
The laser beam can be switched off through a software command (see also the GeniusPlus Help On Line).
WARNING:
Use of controls or adjustments or performance of procedures other than those specified herein may
result in exposure to hazardous visible laser light.
The laser light is visible to the human eye and is emitted from the window on the front of the scanner. Warning labels
indicating exposure to laser light and the device classification are applied onto the body of the scanner.
Disconnect the power supply when opening the device during maintenance or installation to avoid exposure to hazardous
laser light.
The laser diode used in this device is classified as a class 3B laser product according to EN 60825-1 regulations and as a
Class IIIb laser product according to CDRH regulations.
Any violation of the optic parts in particular can cause radiation up to the maximum level of the laser diode (35 mW at 630
to 680 nm).
FCC Compliance
Modifications or changes to this equipment without the expressed written approval of Banner Engineering Corp could void
the authority to use the equipment.
This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
which may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Power Supply
This product is intended to be installed by Qualified Personnel only.
This accessory device is intended to be supplied by a UL Listed or CSA Certified Power Unit with «Class 2» or LPS power
source, which supplies power directly to the scanner via the 25-pin connector.
TCNM-AD Barcode Scanner
16
www.bannerengineering.com - tel: 763-544-3164
P/N 175718 Rev. A
