Banner iVu BCR Gen2 Series, Быстрый старт

Страница: 2 / 12

Installing and Connecting the Sensor
The iVu BCR sensor requires a bracket for mounting. Three brackets are available from Banner. The brackets allow the
sensor to be mounted either perpendicular to the part or at an adjustable angle.
Thread three M4 x 4mm screws through the bracket into the mounting holes in the bottom of the sensor. Tighten all three
screws.
Table 1: iVu Brackets
SMBIVURAL SMBIVURAR SMBIVUU
Cable Connections for iVu BCR with Integrated Display
The cable connections on the iVu BCR sensor are shown below, and the power I/O connections (B) are defined in Table 2
on page 2.
A USB Connector
B Power I/O Connector
NOTE: Micro video lens model shown. C-Mount model
connections are identical.
Table 2: Power I/O Connections
Pin # Wire Color Description Direction
1 White Output 1 Output
2 Brown 10-30V dc Input
3 Green Output 2 Output
4 Yellow Strobe Out (5V dc only) Output
5 Gray Remote Teach Input
6 Pink External Trigger Input
7 Blue Common (Signal Ground) Input
8 Red Ready Output
9 Orange Not used N/A
10 Light Blue RS-232 TX Output
11 Black RS-232 Signal Ground Output
12 Violet RS-232 Rx Input
Cable Connections for the iVu BCR with a Remote Display
The cable connections on the iVu BCR sensor are shown below, and power I/O connections (B) are defined in Table 3 on
page 3.
iVu BCR Gen2 Series Sensor
2 www.bannerengineering.com - Tel: +1-763-544-3164 P/N 178445 Rev. A