10
For the American market only…
This equipment complies with Part 68
of the Federal Communications
Commission (FCC) rules for the
United States.
A label is located on the underside of
the base unit containing either the
FCC registration number and Ringer
Equivalence Number (REN). You must
upon request, provide the following
information to your local telephone
company:
USOC Jack Type: RJ11
REN: 0.1B
Should you experience trouble with
this telephone equipment, please
contact:
Bang & Olufsen America, Inc.
780 West Dundee Road
Arlington Heights, IL 60004
U.S.A.
Phone:
(847) 590-4900
Main Fax: (847) 255-7805
The REN is used to determine the
quantity of devices which may be
connected to the telephone line.
Excessive RENs on the telephone line
may result in the devices not ringing
in response to an incoming call. In
most, but not all areas, the sum of
RENs should not exceed five (5.0). To
be certain of the number of devices
that may be connected to a line, as
determined by the total RENs, contact
the local telephone company.
If trouble is experienced with
BeoCom 1, for repair or warranty
information, please contact:
Bang & Olufsen America, Inc.
780 West Dundee Road
Arlington Heights, IL 60004
U.S.A.
Phone:
(847) 590-4900
Main Fax: (847) 255-7805
If the equipment is causing harm to
the telephone network, the
telephone company may request that
you disconnect the equipment until
the problem is resolved.
This equipment cannot be used on
public coin phone service provided by
the telephone company. Connection
to party line service is subject to state
tariffs.
Your telephone company may
discontinue your service if your
equipment causes harm to the
telephone network. They will notify
you in advance of disconnection, if
possible. During notification, you will
be informed of your right to file a
complaint to the FCC.
Occasionally, your telephone company
may make changes in its facilities,
equipment, operation, or procedures
that could affect the operation of
your equipment. If so, you will be
given advance notice of the change to
give you an opportunity to maintain
uninterrupted service.
Changes or modifications not
expressly approved by the party
responsible for compliance could void
the user's authority to operate the
equipment.
This equipment complies with FCC
radiation exposure limits set forth for
an uncontrolled environment. This
device complies with FCC SAR limit of
1.6 mW/g.
The maximum SAR value measured was
0.082mW/g. This device must not be
co-located or operating in conjunction
with any other antenna or transmitter.
NOTE: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications.
However, there is no guarantee that
interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
– Consult the dealer or an experienced
radio/TV technician for help.
Содержание BEOLINE
Страница 1: ...BeoLine Guide...
