Push button functions 17
Push button functions
State
SELECT
STORE
Time
Comment
Scan
X (short)
-
≤1.5 s
In non-configuration mode: Scans for wireless speakers
In configuration mode: Lit Power Link LEDs to show the number of speakers found
Store default
-
X (short)
≤1.5 s
Scanning completed: store default. Note: when SUB 2.1 is set to On, manual configuration is forced
Show Power Link channel
-
X (long)
≥ 1.5 s and ≤10 s
Show status on Power Link LEDs (turns Off after 10 s time-out)
Manual configuration mode
X (long)
-
≥ 1.5 s and ≤10 s
Configuration mode: Mode for manually configuring the match between the sound channel and a
speaker
Shift noise to next speaker
X (short)
-
≤1.5 s
Configuration mode: Move emitted noise to another speaker
Finish manual configuration *
X (long)
≥ 1.5 s and ≤10 s
Configuration mode: Finish manual configuration whenever desired
Store
-
X (short)
≤1.5 s
Configuration mode: Stores the configuration of the match between the sound channel and a
speaker and continue with next channel
Store *
-
X (long)
≥ 1.5 s and ≤10 s
Configuration mode: Stores the configuration of the match between the sound channel and a
speaker and remain on same channel to be matched with another speaker
Below: Press buttons simultaneously!
Cancel
X (short)
X (short)
≤1.5 s
Configuration mode: Move emitted noise one step back to previous sound channel to reconfigure an
inadvertently stored configuration
Reset association
X (long)
X (long)
≥ 1.5 s and ≤10 s
Erase speaker mapping.
Bang & Olufsen speakers will then flash green. If not press (long) the
RESET
button on the speaker(s)
Factory reset
X (very long) X (very long)
≥ 10 s
Erase speaker mapping, and resets the settings to factory default
Bang & Olufsen speakers will then flash green. If not press (long) the
RESET
button on the speaker(s)
* Functions available with the SW ver. 1.1 and newer.
Note: The cancel function me be used whenever a configuration of a speaker with at sound channel is to be regretted
If the product is a BeoVision 11/BeoPlay V1 or BeoSystem 4, it is possible to press the
STORE
button when the scan is completed. All configuration
of the speakers can then be handled via the SPEAKER CONNECTIONS menu.