Connecting source systems to BeoLab Transmitter 1 13
Right stereo channel
- Short press once or repeatedly on
SELECT
until the noise is emitted from a speaker that shall be configured with the right sound channel.
- If more speakers shall be configured for the right sound channel (else go to next bullet), make a long press on
STORE
, and the WIRELESS LED on
the BeoLab Transmitter 1 turns solid green, to confirm that the speaker configuration is stored for the right sound channel. When the
STORE
button is released the WIRELESS LED continues fast flashing green.
Noise will now be emitted from another speaker and the LED for the right sound channel is flashing. Continue at the step above.
- If all speakers are configured for the right sound channel, make a short press on
STORE
, and the WIRELESS LED on the BeoLab Transmitter 1 turns
solid green, to confirm that the speaker configuration is stored for the right sound channel.
The red LED for the right sound channel becomes solid.
- If speakers are to be configured with other sound channels or the subwoofer sound channel (else go to next bullet) the white LED for the sound
channel above the PL2 socket starts flashing. LEDs for the other sound channels are Off.
Noise will now be emitted from another speaker.
Either continue by repeating the above procedures for the left stereo channel or continue at configuring the subwoofer sound channel below.
- If subwoofers are not to be configured, all speakers found during the search are configured and the white LED for the left sound channel and the
red LED for the right sound channel switches Off after approx. 10 s.
Subwoofer sound channel
The white LED (L) above the PL2 socket is indicating the subwoofer sound channel.
- Short press once or repeatedly on
SELECT
until the noise is emitted from a speaker that shall be configured with the subwoofer sound channel.
- If more speakers shall be configured for the subwoofer sound channel (else go to next bullet), make a long press on
STORE
, and the WIRELESS
LED on the BeoLab Transmitter 1 turns solid green, to confirm that the speaker configuration is stored for the subwoofer sound channel. When the
STORE
button is released the WIRELESS LED continues fast flashing green.
Noise will now be emitted from another speaker and the LED for the subwoofer sound channel is flashing. Continue at the step above.
- If all speakers are configured for the subwoofer sound channel, make a short press on
STORE
, and the WIRELESS LED on the BeoLab Transmitter 1
turns solid green, indicating that the speaker configuration is stored for the subwoofer sound channel.
The white LED for the subwoofer sound channel becomes solid and switches Off after approx. 10 s.
Speaker setup in TV products
When the sound source is a Bang & Olufsen TV, the speakers must be set up via the menus of the TV, see
page 12
ff.
Finish/interrupt manual configuration
Whenever desired the manual configuration can be finished or interrupted by long press
SELECT
. The already configured speakers will be kept
stored, and the speakers not configured will not be playing.
When all speakers are configured, the speakers make a short boot, the LED on the speakers turn solid red and then turns Off. The LEDs above the
PL sockets turns solid for at few seconds and then fade out.