18
Polishing motor 2967 00
3. Push the polishing tip for the right side of the motor (Fig. 11/2) up to the stop
(Fig. 12/arrow).
4. Tighten the clamping screw (Fig. 7/2) using a 2.0 mm hex key (not included
in the delivery) through the passing hole (Fig. 11/1) on the motor shaft (Fig.
11/2). If necessary, turn the polishing tip a little until the clamping screw can
be seen in the passing hole.
5. Check by hand that the polishing tip is firmly fixed. The polishing tip for the
right side of the motor is attached.
6.3 Connect the unit to the power supply
NOTICE!
NOTICE!
The instrument may be damaged by incorrect power
supply!
Incorrect power supply can result in damage to the instru-
ment.
•
Only connect the instrument to an earthed wall socket
that conforms to the technical data.
Personnel: Specialized personnel
1. Insert the power plug of the instrument into the earthed wall socket.
2. Ensure that the power cord is positioned so that it is not a trip hazard.
Starting operation
Fig. 12: Polishing tip, right motor side
