17
Polishing motor 2967 00
6
Starting operation
6.1 Requirements for the assembly site
•
The assembly surface must be level and horizontal.
•
The instrument must not be exposed to splashing or flowing water or other
fluids.
•
The instrument must not be exposed to heat or direct sunlight.
•
The instrument must not be able to fall from the workbench.
6.2 Attach polishing tip
Attach polishing tip for left side of motor
Personal: Fachpersonal
1. Motor shaft
2. Clamp face
1. Push the polishing tip for the left side of the motor (Fig. 9/1) up to the stop
(Fig. 10/arrow).
2. Tighten the clamping screw (Fig. 10/1) using a 2.0 mm hex key (not included in
the delivery) on the clamping face (Fig. 9/2).
3. Check by hand that the polishing tip is firmly fixed. ð The polishing tip for the
left side of the motor is attached.
Personnel: Specialized personnel
1. Passing hole
2. Motor shaft
3. Mounting pin
1. Push polishing tip for the right side of the motor onto the motor shaft
(Fig. 11/2).
2. Turn the polishing tip until the mounting slot (Fig. 7/1) is positioned over the
mounting pin (Fig. 11/3).
Starting operation
Fig. 9: Motor shaft,
left side
1
2
Fig. 10: Polishing tip,
left motor side
Fig. 11: Motor shaft, right side
1
2
3
