Technical data • Individual components
Chapter 2
Technical data
Panel PC 2100 swing arm user's manual V1.12
105
Model number
5ACCIF01.FPLS-000
Operating conditions
EN 61131 pollution degree
Pollution degree 2
Environmental conditions
Temperature
Operation
-20 to 55°C
Storage
-20 to 60°C
Transport
-20 to 60°C
Relative humidity
Operation
5 to 90%, non-condensing
Storage
5 to 95%, non-condensing
Transport
5 to 95%, non-condensing
Mechanical characteristics
Weight
25 g
Table 106: 5ACCIF01.FPLS-000 - Technical data
1)
Yes, although applies only if all components installed within the complete system have this certification and the complete system itself carries the corresponding
mark.
2)
Yes, although applies only if all components installed within the complete system have this certification.
3)
For more information, see Automation Help (Communication - POWERLINK - General information - Hardware - IF / LS).
3.4.4.3.1 POWERLINK interface - Pinout
The POWERLINK interface on the system unit is referred to as IF1.
POWERLINK - IF1
1)2)
Cabling
S/STP (Cat 5e)
Cable length
Max. 100 m (min. Cat 5e)
Status LED
On
Off
Green
See Status/Error LED.
Link LED
On
Off
Yellow
Link (POWERLINK net-
work connection available)
Activity (blinking - da-
ta transfer in progress)
RJ45, female
1
Status LED
Link LED
Table 107: 5ACCIF01.FPLS-000 - POWERLINK interface
1)
The interfaces, etc. available on the device or module have been numbered as such for easy identification. This numbering may differ from that used by
the particular operating system.
2)
This interface is referred to as IF1 in Automation Studio / Automation Runtime.
3.4.4.3.2 COM A serial interface - Pinout
The COM A serial interface on the system unit is referred to as IFx.
Serial interfaceCOM A - IFx
1)2)3)
RS232
Type
RS232, modem-capable, not electrically isolated
UART
16550-compatible, 16-byte FIFO
Transfer rate
Max. 115 kbit/s
Bus length
Max. 15 m
Pin
Assignment
1
DCD
2
DSR
3
RXD
4
RTS
5
TXD
6
CTS
7
DTR
8
RI
9
GND
10
GND
10-pin, male
1 3 5 7
2 4 6 8 10
9
Table 108: 5ACCIF01.FPLS-000 - COM A interface
1)
The interfaces, etc. available on the device or module have been numbered as such for easy identification. This numbering may differ from that used by
the particular operating system.
2)
This interface (if available) is enabled automatically in BIOS as COMA with default I/O address 3F8h and IRQ 4.
3)
This interface is referred to as IF5 in Automation Studio / Automation Runtime.
