Installation • Installation
Chapter 3 Installation
Panel PC 2100 swing arm user's manual V1.00
87
1.4 Connecting the cables
Read the information in the section "Cable connections" on page 94 before connecting the cables.
1. Remove the Panel PC interface cover by following the steps provided in the section "Removing the interface
2. Connect the necessary cables to the interfaces and tighten the locating screws.
Figure 43: Connecting the cables
3. Make sure the seal is positioned correctly.
4. Replace the interface cover on the Panel PC using the 9 to 12 Torx screws (T10) removed earlier (0.6 Nm
tightening torque).
The interface cover must be installed correctly to ensure IP65 protection.