37
FPLMP138
FPLMP138
In
more
detail
. . .
Maintenance table with schedules
Part
To do
Before/ after
each
use
First month
or
5
hours
Every
3
months
or
25
hours
Every
6
months
or
50
hours
Every year
or
100
hours
Every
2
years
or
250
hours
Engine oil
check
x
replace
x
Air filter
check
x
clean
x
replace
x
Spark plug
check/adjust
x
clean
x
replace
x
Spark plug cap
clean
x
Fuel tank
clean
x
Fuel tube
clean
Every
2
years (replace if necessary)
Valve clearance
check/ adjust
x
Muffler
check
x
clean
x
replace
x
Combustion chamber
clean
Every
200
hours
Flywheel brake pad
check
x
Underbody and cutting means
WARNING!
Wear protective gloves when working on the cutting means (
26
)
and close to it! Use proper tools to remove debris, e.g. a wooden stick! Never
use your bare hands!
Always use original spare parts for replacement. The cutting means must be
replaced by an identical type with the reference number SMV 1816211. Do
not attach any other type of cutting means (
26
)!
The replacement of the cutting means (
26
) should be done by an experienced
operator! Rework or sharpening blades is not recommended unless it is done
by a repair service or a similarly qualified specialist!
NOTE:
We strongly recommend jacking the product when performing inspection
and work on the cutting means (
26
). Avoid tilting the product in order to prevent
fuel and oil leakages.
1. Keep the underbody and cutting means (
26
) clean and free of debris. Remove
clippings from the discharge chute (
28
).
2. Check all nuts and bolts periodically for tightness before the operation. After prolonged
use, especially in sandy soil conditions, the cutting means (
26
) will become worn
and lose some of the original shape. The cutting efficiency will be reduced, and the
cutting means should be replaced.
3. Keep the cutting means (
26
) sharp to ensure a good cutting performance. Replace
a worn or damaged cutting means (
26
) with a new one of the same type or have it
sharpened by a qualified specialist.
4. If jacking the product is not possible, tilt it to the right side so that the fuel tank cap
(
9a
) side is up. This helps to prevent fuel leakage and harder starting due to flooding
of the carburettor.
5. Loosen the hex bolt (
26e
) anti-clockwise and remove it together with the washer (
26d
)
and cutting means (
26
) (Fig.
20
).
6. Replace the cutting means (
26
) with a new one of the same type. Secure with washer
(
26d
) and hex bolt (
26e
). Tighten the hex bolt clockwise with
40
-
45
Nm force to
ensure safe operation of the product (Fig.
20
).
DANGER!
If the cutting means (
26
) are not torqued properly, they could become
loose and be thrown from the product and seriously hurt or kill the operator
or bystanders.
NOTE:
Replace the cutting means (
26
) after
50
hours of mowing, or
2
years
whichever is sooner regardless of condition. If the cutting means (
26
) is cracked
or damaged, replace it immediately.
Care and maintenance
3663602423287-GB-V04.indd 37
27/9/2018 14:55
