OPERATION OF THE TELEVISION ANALYST
In order to become familiar with the operation of the Television Analyst
it is suggested that you set up, on a bench, an operating TV receiver. In this
way you will become familiar with the procedure and with the available
signals and their uses. Assume that you have an operating TV receiver before
you and a B & K Television Analyst. The Television Analyst must first be
set up as per instructions on page 7.
1. Plug the Television Analyst into a 117 volt, 60 cycle, single-phase
A.C. power outlet. Turn power switch to "Stand-by" position.
2. Connect one end of the R.F. test cable to the R.F. OUTPUT JACK
on the front panel. Connect the other end of this cable to the
antenna terminals on the receiver.
3. Lift cover of Analyst and insert test pattern slide into slide track.
Push slide all the way. See Fig. 3. When viewing the slide from the
left side of the instrument, the word "FRONT" should read correctly
as it is being dropped into the slide track.
Figure 3-Inserting slide in TV Analyst
4. Turn the Television Analyst power switch to "ON".
5. Set the Channel Selector of the TV set at an unused channel, pre
ferably Channel 6 or below. Set Analyst Channel Selector to the
same channel.
6. Set the R.F. ATTENUATOR to number 5. Adjust fine tuning of
monitor TV, if necessary.
7. Set brightness and contrast of monitor TV receiver at normal position.
Advance VIDEO CONTROL for picture of good contrast. Adjust
the VIDEO CONTROL so that the full range of grays near the
center of the pattern is visible. If the VIDEO CONTROL is set
too high, the picture will tend to overload and distort.
8. The HORIZONTAL CONTROL is adjusted in the following manner.
Hook TV antenna and R.F. leads from Analyst to the antenna
terminals of the monitor receiver. Tune monitor TV receiver to an
On-the-Air TV station signal. Select the same channel on the
Television Analyst, and a setting of the R.F. Attenuator, that will
permit both pictures to be seen on the receiver. Adjacent channel
9
")
,·/:1
Содержание 1076
