B&G RAM T2, Руководство пользователя

Страница: 14 / 20

14
The motor is a non-serviceable item and should be replaced with a new
motor and drive coupling Kit.
Part Nos. 12V UNITS = R4510-sk 12 100 X
24V UNITS = R4510-sk 24 100 X
Quote your units serial number when ordering Ref. page 19)..
The motor can be replaced without affecting the integrity of the hydraulic
circuit.
To remove the motor:
Undo the two M6 socket head cap screws and remove the motor, coupling
and water seal O ring.
If the coupling is worn or damaged replace. Lubricate the slots with a small
quantity of good quality grease.
If any hydraulic fluid is found in the coupling area the shaft seal must be
replaced – see service kit ML+40sk for instructions.
Reassemble by replacing the O ring, engage the coupling between the
motor and pump shafts, ensure the motor locates correctly in the pump
spigot.
Using low strength thread locking compound, replace and tighten the two
M6 socket head cap screws. (13.5 Nm).
Caution
Keep all parts clean during dismantling and reassembly.