B&G Hydra 2000, Руководство пользователя

Страница: 103 / 147

Hydra 2000 User Manual
Part 5 - Options
HB-0844-02
5-6
5.3.2 Analogue Indicator Configuration
If meters other than the defaults are chosen then it is necessary to
reconfigure the outputs
. This is done from any FFD as follows:
(1) Power up the system from any FFD while holding
down the
Enter Key, DIAGNOST appears.
(2) Press Scroll Up, CNFG SYS appears, press Enter to
select this option . Now press Enter again to select the
METERS option.
(3) With OPTIONS flashing, press Enter , METER 1
appears, the Scroll Up Key is now used to scroll through
the meter outputs . (Refer to the installation sheet to
determine the meter options and their respective meter
drives).
(4) With the appropriate meter output flashing in the top
display, press
Enter to reveal the current option assigned
to that meter . Pressing Scroll Up at this stage, and then
Enter again, will reveal the METER 2 option . Repeating
this process will reveal the METER 3 and METER 4
options as required.
(5) Press Enter, the lower text will flash . Use Scroll
Down to scroll through the options until the appropriate
one (e.g . DEPTH) is shown . Pressing Enter will select
that option, and the meter output will be configured to
drive a DEPTH meter.
(6) Press Page to return to normal operation.
Note
It is possible to configure more than one meter drive to the same
meter option (e.g
. BOAT SPD on METER 1 and METER 2).