BANDELIN Sonoplus HD 2070, Инструкция по эксплуатации

Страница: 20 / 44

Continuous operation
Action Display Remark
1
Turning on the generator
Turn the "POWER" control dial
all the way to the left. Activate
the mains switch
- the display lights up
after 3 seconds.
MIN/SEC: last set value
CYCLE: last set value
("-" = Max.)
POWER: 000 %
The green control light is lit.
When the generator is turned on, the
most recently used operating mode
becomes active.
It is possible to switch to countdown
operation using the RESET key.
2
Start
Press the START/STOP key
on the generator or transducer,
or activate the foot switch.
MIN/SEC: runs forward
CYCLE: set value
POWER: for the moment in
%
During operation, the POWER should
be set and is modi
fi able. If a time of
99 min 59 sec is reached, zeros are
displayed and operation continues.
After the start-up process,
the generator will not react to
further key presses!
3
Interrupting
Press the START/STOP key
on the generator or transducer,
or activate the foot switch.
MIN/SEC: elapsed time
CYCLE: set value
POWER: 000 %
During the interruption, the colon
fl ashes between MIN/SEC.
The user has the option of entering
new settings or
continuing operation.
- Currently saved settings
4
Continuation
Press the START/STOP key
on the generator or transducer,
or activate the foot switch.
MIN/SEC: time continues to
run forward
CYCLE: set value
POWER: for the moment in
%
5
Cancelling
Press the RESET key
MIN/SEC: 00 min 00 sec
CYCLE: set value
POWER: 000 %
The user can restart, or switch to
countdown operation by pressing the
RESET key.
6
Switching to countdown
operation
After cancelling, press the
RESET key once again.
MIN/SEC: last saved value
CYCLE: last saved value
POWER: 000 %
Any other time than 00:00 means:
continuous operation is inactive.
In countdown operation, the setting
00:00 is not an option and will also
not be displayed.
7
Turning off the generator
Turn the control dial (POWER)
all the way to the left. Activate
the mains switch.
The display goes out.
The control light is no longer lit.
The last set program is retained.
After powering off, a pause of
approx. 10 sec must be observed
before turning the device on again.
The saved continuous operation is
retained.
Caution ! Observe the maximum allowed amplitude setting for the probes - chapter 4.3.
20 / 44 51436a GB/2017-10
1 electronic GmbH & Co. KG • Heinrichstraße 3-4 • 12207 Berlin • Deutschland • info@bandelin.com