B&D Doors is a division of B&D Australia Pty Ltd
P: 13 62 63
W: www.bnd.com.au
Mount the Charger Board
a. Unplug the drive unit from mains power.
b. Remove screws and swing open the cover.
c. Mount the PCB support
15
with two screws
13
. Secure the charger board
8
on to PCB support with 3 screws
14
.
d. Unscrew the 2-wire SBY-2 battery harness
10
from the 2 pin connector on
the charger board
8
. Feed the 2-wire SBY-2 battery harness
10
through the
grommet on the base plate and secure back on the 2 pin connector.
e. Remove two (2) screws from the Light Diffuser to access the main control
board.
f. Remove the shunt from the 5 pin connector on the control board. Feed the
charger harness
9
from the charger board
8
through the cover and insert
into the 5 pin connector on the main control board.
Mount & Connect the Battery
a. Mount battery pack on side of unit and secure with items
11
and
12
.
WARNING:
After Step (b) the opener may become active (even when
power is off). This is a result of a residual charge in the batteries.
b. Connect battery harnesses
5
and
10
together.
c. Close the cover, secure the Light Diffuser with 2 screws and reconnect
power.
NOTE:
Batteries may take up to 48 hours to charge fully after initial installation.
Re-setup and Test the Opener
a. Reconnect power and remove button cover.
b. Press either the OSC button the opener or the programmed transmitter
button to test the battery backup installation.
c. Whilst door is in motion, disconnect mains power. The door should continue
to operate as normal.
NOTE:
Wait for the door to complete its travel.
d. Press either the OSC button on the opener or the progammed transmitter
button to activate the door.
e. Whilst door is in motion, reconnect power and re-install button cover. The
door should complete the cycle as normal.
Grommet
Light Diffuser
Overhead Door Opener Set Up
GDO-9V2 GEN2 Enduro, GDO-9V3 GEN2 Dynamo, SDO-2V2 CAD P Diamond,
SDO-2V2 CAD Advance, SDO-2V3 CAD Prodigy & SDO-3V2 CAD S
SDO-2V3 Prodigy:
The Charger board is already installed with the unit.
Please proceed to Mount & Connect the Battery
.
