Bame Delma POLARIS 4, Руководство пользователя

Страница: 16 / 24

Setting the remote control codes
1. Press P1 and P2 simultaneously for three seconds
to begin programming the board.
2. Letter A appear on the display. Scroll the menu with P1
until letter C appears on the display.
Press P2 to confirm.
3. You should see 1 on the display.
Press P2 to confirm.
4. You should see 0 on the display.
Push the button on the remote to be learned.
ATTENTION!!!!!! When entering a code already stored, the code will be deleted from the memory of the board.
Parameter C1: step by step logic code (start/stop)
1. Press P1 and P2 simultaneously for three seconds
to begin programming the board.
2. Letter A appear on the display. Scroll the menu with P1
until letter C appears on the display.
Press P2 to confirm.
3. You should see 1 on the display. Scroll the values
with P1 until 2 will appear on the display.
Press P2 to confirm.
4. You should see 0 on the display.
Push the button on the remote to be learned.
ATTENTION!!!!!! When entering a code already stored, the code will be deleted from the memory of the board.
Parameter C2: non step by step logic code (open)
- 16 -
If using dipswitches remote controls before learning them on the control board, please set a personal
code with the dipswitches positioned inside the remote control.
During the learning of the remote controls we advice to disconnect the antenna and do not employ too
much time to send the code of the remote control, specially in urban areas where there are many radio
disturbs.
To comply with the European Specifications the gate must be opened on sight (15 meters), therefore the
remote controls are set to work within this distance to avoid dangerous situations and radio pollution (see
the point above).