baltur TBG 80 LX ME /V, Инструкция по установке, использованию и обслуживанию

Страница: 64 / 92

To ensure correct operation of the air pressure switch you must, with
burner on and in 1st stage, increase its regulation value until the bur -
ner triggers and then it immediately “locks-out”.
To unblock the burner, press the special pushbutton and return the
pressure switch regulator to a sufficient value in order to measure the
air pressure existing during the pre-ventilation phase.
The gas pressure control switches (minimum and maximum) prevent
the burner from operating when gas pressure does not lie between
the expected range.
The minimum value pressure switch makes use of the NO (normally
open) contact which is closed when the pressure switch detects a
pressure higher than its own setting.
The maximum pressure switch uses the NC (normally closed) contact
that is closed when the pressure switch detects a pressure lower than
the value it is set to.
Adjustment of minimum and maximum pressure values on the pres -
sure switches must be performed when testing the burner, on the
basis of the pressure measured in each case.
The triggering (opening of the circuit) of any of the pressure switches
when the burner is running (flame on) locks out the burner immedia -
tely.
When first switching on with burner lockout, it is essential to check
that they work properly.
Verify the flame detector operation as follows:
• disconnect the wire coming from the ionisation electrode;
• start the burner;
• the equipment will complete the control cycle and after two seconds
will lock out the burner due to the lack of ignition flame;
• switch off the burner;
• reposition the photocell;
• This test should also be conducted with the burner already on;
when extracting the photocell from its seat, the apparatus should
shut down immediately.
• check the efficiency of the thermostats or boiler pressure switches
(they should shut down the burner when triggered)
• check the efficiency of the temperature probe in the boiler, it should
shut down the burner when triggered.
• The compressor starts together with the burner.
• When the burner stops the post-ventilation function is activated and
also the compressor remains in operation for 120 sec.
• Check that the compressed air pipe outlet is supplied during ope-
ration.
CAUTION / WARNINGS
Check that the ignition takes place properly. In the event that
the mixer is too far forward, it may happen that the speed of the
delivery air is so high that ignition is difficult. If this happens,
the mixer must be gradually shifted back until it is in a position
in which ignition occurs normally, and this new position can be
regarded as the final position.We remind you that is preferable,
in the case of the small flame, to limit the quantity of air to the
lowest amount possible needed for safe ignition, even in the
most difficult circumstances.|bb|
IONISATION CURRENT MEASUREMENT
The maximum ionisation current value required for a correct opera -
tion of the equipment is indicated in the wiring diagram.
The burner provides a significantly higher current and therefore does
not normally require any checks at all.
To measure ionisation current, connect a microammeter in series with
the ionisation electrode cable as shown in the figure.
FLAME SENSOR
Verify the flame detector operation as follows:
• disconnect the wire coming from the ionisation electrode;
• start the burner;
• the equipment will complete the control cycle and after two seconds
will lock out the burner due to the lack of ignition flame;
• switch off the burner;
• re-connect the wire to the ionisation electrode.
• This test should also be conducted with the burner already on; the
apparatus should shut down immediately when the wire from the
ionization electrode is disconnected.
ENGLISH
18 / 44
0006081328_202001