baltur TBG 80 LX ME /V, Инструкция по установке, использованию и обслуживанию

Страница: 57 / 92

BURNER CONNECTION TO THE BOILER
HEAD UNIT ASSEMBLY
The combustion head is packaged separately from the body of
the burner.
Anchor the head unit to the boiler door as follows:
• Adjust the position of the coupling flange (19) by loosening the
screws (6) so that the burner head enters the furnace to the
extent recommended by the generator manufacturer.
• Position the insulating gasket (13) on the sleeve, by inserting
the cord (2) between the flange and the gasket.
• Fasten the head unit to the boiler(1) by means of the stud bolts,
washers and the nuts provided (7).
DANGER / ATTENTION
Seal the space between the burner sleeve and the hold
on the refractory material inside the boiler door completely
with suitable material.
ASSEMBLING THE GAS TRAIN
The EN 676 approved gas train is sold separately from the bur -
ner.
The gas train can be assembled in different ways: (1), (2), (3).
Choose the most rational position for the set-up of the boiler room
and the position in which the gas pipeline arrives.
DANGER / ATTENTION
In case of very large valves, e.g. DN65 or DN80, make
sure there is a suitable support to prevent excessive stress
on the gas train fitting.
ASSEMBLY OF VENTILATION SYSTEM
Use the specific chains or ropes connected to the respective eye -
bolts and slots (21) of the burner.
For a correct installation of the ventilating body, follow the proce -
dure described below:
Position the half-hinge on the burner scroll in line with those on
the combustion head assembly.
• Insert the hinge pin (10) in the position considered most sui-
table
• Connect the cables (switch on and ionisation) to the corre -
sponding electrodes, close the hinge, locking the burner by
means of screws (11).
1
2
13
0002934720
19
7
6
1
3
2
0002934960
ENGLISH
11 / 44
0006081328_202001