BAM MD-VS-001-x
Base Station/Charger
2
Installation
8
2.1.3
Mounting for Portable Use
If portability of the cradle is required, the metal plate must be used. There are two ways this
can be done: (1) by first mounting the metal plate on a flat surface so the cradle can be slid
off and on, or (2) mounting the metal plate onto the back of the base station and then screw-
ing both to the desired surface.
Mounting the Metal Plate
1
Affix the metal plate onto the desired mounting surface using the two center screw
holes (see
Figure 4 on page 8
).
2
Remove the adhesive strips protecting the mounting tabs on the cradle, shown in
Fig-
ure 3
.
3
Slide the tabs on the back of the cradle onto the metal plate as shown in
Figure 4:
.
4
After aligning the tabs, push up to lock into place.
Figure 4:
Mounting Plate on wall
l
NOTE
For additional security on wall mounting, it is strongly recommended
that the cradle be secured into place using two auxiliary screws
through the mounting holes on the side.