Page 22
IBVR20 software 8.43.doc
Issue 1
The message selection functions from the BVRM microphone may be set using the
mode settings on each port, as shown in the following table.
Mode
Message ‘Select’ and ‘Cancel’
Function
00
When all zones are unselected, message
select and cancel do not all call / select
Unselected zones will not automatically alert.
01
As above
Message 1 will select all unselected zones to message 2
02
As above
Message 2 will select all unselected zones to message 3
03
As above
Message 3 will select all unselected zones to message 4
04
Select only has an all call function
Unselected zones will not automatically alert
05
As above
Message 1 will select all unselected zones to message 2
06
As above
Message 2 will select all unselected zones to message 3
07
As above
Message 3 will select all unselected zones to message 4
08
Cancel only has an all select function
Unselected zones will not automatically alert
09
As above
Message 1 will select all unselected zones to message 2
10
As above
Message 2 will select all unselected zones to message 3
11
As above
Message 3 will select all unselected zones to message 4
12
Both Select & Cancel have all call / select
Unselected zones will not automatically alert
13
As above
Message 1 will select all unselected zones to message 2
14
As above
Message 2 will select all unselected zones to message 3
15
As above
Message 3 will select all unselected zones to message 4
To set the mode. Move the cursor along until it flashes beneath the MODE window.
Values between 0-9 may be entered directly using the numbered keys.
Note the cursor automatically steps to the next window. Or using the + or – keys will increase
or decrease the value between 00 and 15.
9. Press the Page down key again.
The display steps to the page microphone mode.
------------------------------------------
| P1&2 out|01-04|05-08|09-12|13-16|17-20 |
| page mode|00|00|00|00|00|00|00|00|00|00 |
------------------------------------------
Normal paging from BVRM microphone may be barred to any of the zone outputs 01-20
by entering a code in the section below the required zone output. The first section is
assigned to Port 1 and the second to Port2.
------------------------------------------
| P1&2 out|01-04|05-08|09-12|13-16|17-20 |
| page mode|00|00|00|00|00|00|00|00|00|00 |
------------------------------------------
Port1
Port2
To enter a code move the cursor along until it flashes beneath the window of output required.
Values between 0-9 may be entered directly using the numbered keys or using the + or –
keys will increase or decrease the value between 00 and 15.
