BVRD Network
Installation Instructions
8
BVRDNET issue 3
Connect the “Local” BVRD2M/4 to the BVRDCIF, using either
the P2 or P3 RJ45 connection, and
note which is being used
.
N
OTE
: The LED on the BVRDCIF will not flash until the network is
connected and receiving data.
3.1.2 “Remote” Network connection
Go to the “Remote” unit.
Connect the site wiring to the “Remote” BVRDCIF, ensuring the
connections match the screen printed colour codes (or is
consistent with the connection details of the “Local” unit if the site
cables do not match the screen printed colour codes).
Ensure the “Remote” BVRD2M/4 is switched on and the network
is enabled in configuration.
Connect the BVRD2M/4 to the OTHER RJ45 connector on the
BVRDCIF i.e. if P2 was used for the “Local” unit, connect the
“Remote” unit to P3.
Refer to Figure 2.3 for connection details.
The LEDs on the BVRDCIF modules should now flash regularly
to indicate data is being received.
If the LEDs do not flash then refer to “Fault Finding” on page 10.
