Baldor PC1100R, Инструкция по установке и эксплуатации

Страница: 24 / 26

5-4 Troubleshooting and Maintenance MN2411
Service Service for your generator can be obtained from Baldor Generators. Please have the following
information available prior to contacting the factory:
The model number and serial number of the generator set.
A complete and accurate description of the problem.
Parts Parts for your generator can be obtained from Baldor Generators. Please have the following
information available prior to contacting the factory:
The model number and serial number of the generator set.
A complete and accurate description of the part (part number if known).
Engine Oil (SE or higher grade) SAE 10W − 30 or SAE 10W − 40
Use class SE (API classification) or better grade oil. SAE 10W − 30 or SAE 10W − 40 is
recommended for general use. For single viscosity oil use at a specific temperature, refer to the
following chart.
Single Grade
Multigrade
Ambient
Temperature −20
4
−10
14
0
32
10
50
20
68 30
86
40
°
C
104
°
F
10W 30
10W 40
5W
10W
20W
30W
40W
Storage If you will not be using the generator set for a significant amount of time (3 months or longer) you
should store the generator to prevent any problems that could arise from sitting idle. Please
follow this procedure prior to storing the unit. This will help to ensure that the generator will start
and provide good service when it is removed from storage.
1. Remove fuel filler cap.
2. Use a siphon pump to remove all fuel from fuel tank.
3. Install fuel filler cap.
4. Start the generator set and allow it to run out of fuel.
5. Place the Engine Switch in “Stop” position. This closes the fuel valve.
6. Drain the used oil from the engine’s crankcase and refill it with clean oil.
7. Remove the spark plug and pour 1 oz. of clean engine oil into the cylinder. Put a rag
over the spark plug port and turn the engine over approximately 5 times to distribute
the oil in the cylinder.
8. Install the spark plug but do not connect the plug wire. This will help prevent accidental
or unauthorized starting.
9. Provide maintenance to the engine and generator set as described in this section.
10. Inspect bolts and nuts for tightness. Vibration can cause nuts or bolts to loosen.
11. Inspect the recoil starting rope for any damage and replace it if necessary.
12. Cover any bare metal spots with paint or another type of rust preventative.
WARNING: Never store an engine with fuel in its tank indoors or in an enclosed, poorly ventilated area
where gasoline fumes could reach an ignition source and cause an explosion.