16
2.6 JUMPER SETTINGS
All jumpers have been factory set for most applications, as shown
in Figure 2-3. Some applications require setting of the jumpers in
order to set the drive for a specific application. Jumper J2 must
be set to match the horsepower of the motor being used. Refer to
Table 1-4 and Chapter 6.
2.7 60Hz and 50Hz MOTOR OPERATION
The drive is factory set for 60Hz motor operation (Jumper J5 set
to the “60Hz” position). See Section 6.4.
2.8 PILOT LIGHT
After applying power to the drive and setting the On/Off AC Line
Switch to the “ON” position, the panel mounted Pilot Light will
illuminate.
2.9 DIAGNOSTIC LEDs
After applying power to the drive and the On/Off AC Line Switch
to the “ON” position.
2.10 TRIMPOT SETTINGS
All trimpots have been factory set for most applications, as
shown in Figure 2-3. Some applications require adjustment of the
trimpots in order to setup the drive for a specific requirement. See
Chapter 7.
Содержание ID5601-EO
Страница 18: ...18 Figure 2 3 Drive Layout ...
