Balcrank Director Jr. 3110-031, Руководство по эксплуатации, установке, обслуживанию и ремонту

Страница: 15 / 18

Symptom Cause Solution
5. System has power and Pump is not operating. Check the air supply to the pump
goes into ready mode, and the pump air solenoid valve.
but no fluid can be
dispensed. Out of fluid. Check the fluid level in the storage
container.
Control solenoid valve not Check valve for energized position.
operating.
Outlet of pump is blocked. Check impulse meter and control
solenoid valve for blockage.
Defective station selector Return the unit for repair.
switch.
System not properly wired. Recheck electrical connections and
rewire as specified.
Cable not connected or properly Plug in cable connector.
seated.
6. Fluid does not cut off Impulse meter set up for the Check the impulse meter for the
at the correct preset wrong units. correct volume per pulse.
Impulse meter cam plate not Check the position of the pulse
actuating pulse switch at each switch in relation to the cam lobes.
cam lobe. The pulse switch is Also check for broken cam lobe.
out of position. Adjust or replace as required per
meter instructions.
Defective unit. Return the unit for repair.
7. Remote “Ready” light Remote “Ready” light bulb Replace bulb.
will not come on, but burned out.
the console “Ready”
light does. Remote “Ready” light improperly Correct or replace remote wiring.
wired or faulty wiring.
14