49-328P50 –
www.hydroair.dk
– February 2009
Genesis Blower
Electrical installation
Note:
All electrical work must be carried out by a qualified electrician according to national wiring rules.
Electrical installations should not be done until the blower is completely installed in its location.
Check the main voltage before connecting the blower.
The blower is fitted with an electrical supply cord which is in compliance with European standards EN60335-2-60
and has the following wire-colour coding:
CLASS I CLASS
II
Earth:
Yellow and Green
Earth: Without
earth
cable
Neutral: Blue
Neutral:
Blue
Live:
Brown
Live:
Brown
The installation of the whole system must be done using a fixed wiring switch that has a contact separation of at
least 3 mm. in each pole. If the single-speed blower is fitted to an external variable speed control box, the blower
must run at high speed for at least 5 seconds.
Note: If the thermal protection for the air-blower motor is activated, the blower will not restart until power from the
system has been cut off and switched on again AFTER the blower has cooled to room temperature.
Maintenance
No special maintenance is required for the blower although the intake filter can be cleaned by dismantling the
base of the blower: to do this, remove the two screws at the back of the blower. The ozone-generated version of
the air blower is in accordance with the COSHH regulations EH38 Ozone: health hazards and precautionary
measures.
If the power-supply cord is damaged, it must only be replaced by the manufacturer, service agent or a similar
qualified agent in order to avoid damage.
Note
Please see the touchpad manual for wire information.
