5
© 2010 Bakker Hydraulic Products B.V.
Nijverheidsweg 6
6662 NG Elst (Gld) The Netherlands
Tel : + 31 481 374757 Fax : + 31 481 375280
2.4 THE HOSES BETWEEN ROTATOR AND CYLINDER:
Note:
When using a rotator purchased from Bakker Hydraulic Products BV the hoses that
connect this rotator and the hydraulic cylinder should be ordered from the
manufacturer. You can then be sure that the hoses are the right length and diameter. If
required, reinforced hoses can be supplied as extras by and in consultation with the
manufacturer.
2.4.1 Mounting the hoses on a rotator with drive shaft:
Fit a hose to one of the hose connections on the rotator shaft (ensure that you have
the right diameter hose). Now fasten the other end of this hose to one of the
connections on the cylinder. Repeat this to connect the second hose.
Note: If the grab bucket does not function properly after mounting the hoses, swap
around the hoses from the crane to the rotator. If the grab bucket still does not
operate to your complete satisfaction, contact the manufacturer or your nearest
dealer.
2.4.2 Mounting the hoses on a rotator with flange fitting
To fit the hose to the hose connection on the hydraulic cylinder, see Section 2.4.1
above. To connect the hose to the rotator, please refer to the rotator manufacturer.
2.5 THE LINK:
Assembly:
A link is always mounted between the rotator and the jib of the crane.
Mount the link at the top of the rotator. Mount the link pin and locking pin.
Check whether the link can move freely. Connect and lock the link to the crane.
Note: Make sure that there is as little sideways slack as possible. If necessary, mount
spacers.
2.6 THE DETACHABLE SIDE PLATES:
Assembly:
A standard feature of the grab bucket is that it has holes for fastening detachable side
plates. The detachable side plates (one set = four plates), which are supplied as
extras, can be fixed to the sides of the grab bucket by means of a few bolts.
To do this, mount two side plates to one side of the grabber and adjust them so that
the grab bucket closes properly (using the slotted holes in the detachable side plates).
Now tighten the bolts well. Do the same on the other side of the grab bucket. Your
grab bucket with side plates is now ready for use.
Caution:
Only use detachable side plates when loading loose material!
Содержание RLO
Страница 1: ...OPERATING MANUAL Grab Bucket RLO ...
