6
© 2010 Bakker Hydraulic Products B.V.
Nijverheidsweg 6
6662 NG Elst (Gld) The Netherlands
Tel : + 31 481 374757 Fax : + 31 481 375280
2.7 THE RUBBER JAWS:
Assembly:
The rubber jaws are available as standard accessories in two different versions and
are fitted with rubber (70 shore):
-
Total length = 1200 mm.
-
Total length = 1700 mm.
When mounting the tile jaws, ensure that the grab bucket is in the open position.
Lay the tile jaws on the ground with the rubbers opposite each other, roughly 1400 mm
apart.
Position the grab bucket above the rubber jaws and slowly lower it until the blades of
the grab bucket are in the appropriate position for the rubber jaws.
After this, slide the hooks (on the load binders) over the top of the side panel.
Now hook the chain of the rubber jaw to the load binder and tighten and lock the whole
structure.
Make sure that the rubber jaw is not loosely suspended.
Note:
When ordering the above rubber jaws, always specify the type and width of the grab
bucket to which the rubber jaws must be mounted.
Also specify the required length of the rubber jaws.
If the rubbers are worn, they must be replaced with new ones.
Содержание RLO
Страница 1: ...OPERATING MANUAL Grab Bucket RLO ...
