7
© 2010 Bakker Hydraulic Products B.V.
Nijverheidsweg 6
6662 NG Elst (Gld) The Netherlands
Tel : + 31 481 374757 Fax : + 31 481 375280
Site :
E-mail :
➢
When the hoisting hook is in use, no persons may be in the
danger zone (under or in close proximity of the grapple).
➢
The load must always be straight below the hoisting hook.
Make sure that chains/nooses and such cannot come into
contact with the blades/jaws of the grapple.
2.7 THE RUBBER JAWS :
Assembly:
The rubber jaws are available as standard accessories in two different
versions and are fitted with rubber (70
shore):
- Total length = 1200 mm.
- Total length = 1700 mm.
When mounting the tile jaws, ensure that the grab bucket is in the open
position.
Lay the tile jaws on the ground with the rubbers opposite each other,
roughly 1400 mm apart.
Position the grab bucket above the rubber jaws and slowly lower it until the
blades of the grab bucket are in the appropriate position for the rubber
jaws.
After this, slide the hooks (on the load binders) over the top of the side
panel.
Now hook the chain of the rubber jaw to the load binder and tighten and
lock the whole structure.
Make sure that the rubber jaw is not loosely suspended.
Note :
When ordering the above rubber jaws, always specify the type and width
of the grab bucket to which the rubber jaws must be mounted.
Also specify the required length of the rubber jaws.
If the rubbers are worn, they must be replaced with new ones.
Содержание BDV 2020
Страница 1: ...OPERATING MANUAL Grab Bucket BDV 2020 ...
