Bakers Pride FC series, Руководство по проектированию и установке

Страница: 14 / 34

IL FORNO CLASSICO OVEN DESIGN & INSTALLATION GUIDE
12
Anyone with some experience laying tile should be able
to complete this project with relative ease.
Step #1 Uncrate oven(s), attach legs, set in place.
Step #2 Attach front sheet metal skirt (provided)
by drilling holes in oven legs using pre-
punched holes in sheet metal skirt as a
template.
NOTE: Bottom flangeo nskirt faces outward.
Step #3 Secure skirt using sheet metal screws.
Step #4 If you plan on finishing the oven sides with
tile, etc, follow steps #2 and #3 for side
skirts.
Step #5 Fasten 3/8” thick fire resistant “Wonder
Board” (7mm) to oven front (and sides if
appropriate) using 1/2”to 5/8” sheet metal
screws. When finishing Lintel Plate, thinner
“Wonder Board” and shorter screws may be
necessary.
NOTE: “Wonder Board” must be cut to fit.
Allow access for push-pull rod holes, oven
control access doors and combustion and
bake chamber doors.
IL FORNO DSP STYLE INSTALLATION
Step #6 Attach tile, stone, thin-brick or the material
of choice over “Wonder Board” using either
a latex/polymer based high-heat ceramic
thin-set mortar, “spec” mix mortar or type
“S” mortar. Best results will be achieved
using tile, etc. no more than 5/8” thick.
NOTE: Start at the floor and work up to top
of oven. Cut stone, etc. to fit as required
based on your design and to create the
look you want.
Step #7 Consider L-shaped tile or brick trim pieces
along front vertical corners and top edges of
oven front and side to complete a finished
look.
Step #8 Grout between brick joints. It is best to
allow the thin-set mortar to dry over night
prior to grouting.
Step #9 Allow grout to dry for 24 hours prior to
starting ovens.
NOTE: Wonder Board equivilents; Harde
Backer Board, various trade names.
Figure 7: FC-616 DSP With Tilework
Figure 8: FC-616 DSP Stacked On Y-600 With Tilework