Baker Hughes 022-508-909, Руководство по эксплуатации

Страница: 25 / 89

CL 5 3-25
3.2 Configuring the Instrument
Prior to using the CL 5 to measure thickness, some
or all of the following parameters must be specified
using the Configuration display shown in Figure 3-3.
• Language – Set the displayed language to English,
German, French, Spanish, Italian, etc.
• Units – Set the unit of measurement to inches or
millimeters
• Resolution – Sets the number of decimal places to
which thickness measurements are displayed
• Update Rate – Update the displayed measurement
at a rate of 4 or 8 Hz
• Radix – Select a period (.) or comma (,) to be used
as a decimal point
• Battery Type – Select from Alkaline, NiCAD, or NiMH
• Auto Power Down – Select ON to automatically turn
the instrument off five minutes after the last key
press (no data will be lost) or OFF to allow the in-
strument to remain on until manually powered off.
• Contrast – Adjusts the display contrast
• Backlight – Adjusts the display lighting (a setting
of ON increases battery usage, a setting of AUTO
causes backlighting to illuminate and remain on
for Five Seconds after each key press.)
Each of these parameters is set the same way:
Step 1: Press multiple times to access the display
(shown in Figure 3-3).
Step2: Press or to select each parameter you would
like to modify.
Step 3: When the desired parameter is highlighted,
press to activate it.
Step4: Press or to adjust the parameter’s value.
Step 5: Press when the parameter is set to the desi-
red value.
Setting Up the CL 5
Configuring the Instrument‘s Display