17
CHANGNG THE OL, CLEANNG OL FLTER SCREEN
1. Remove the “Screw Plug, spring and oil filter screen located at the bottom of the engine
and let the oil drain into an approved collection container. DO NOT PERFORM THS
PROCEDURE WHLE THE ENGNE S HOT. SEROUS BURNS COULD RESULT FROM CONTACT
WTH HOT OL.
2. Dispose of the used oil properly. For proper disposal procedures, contact your local oil
recycling center
3. Clean oil screen and spring with solvent
3. Clean and replace the Screw Plug” tighly.
4. Refill the engine with the proper amount of oil and recheck the amount of oil in the
engine by using the oil gauge plug and/or sight gauge.
Screw plug for oil draining
CHECk-UP OF SPARk PLUG
1. Remove the cap of spark plug and screw off the spark
plug using the plug wrench.
2. Clean the spark plug all around or replace it if it is
corroded or there is too much deposit on it.
3. Regulate the gap of the spark plug to 0.6-0.8mm.
.024” - .032”
3. The spark plug of the designated type should be used.
The applicable type of spark plug: D8EA (NGk)
0.6~0.8mm
(.024” - .032”)
Oil filter screen
Spring
