7 — English
©
2010 Baja, Inc. All Rights Reserved.
ASSEMBLY
INSTALLING HANDLEBARS
Lift handlebars to proper operating position and insert
handlebar bolts into opening in frame as shown.
Install lock washer, flat washer and nylon nut. Tighten nuts
securely. Torque to 20 ft.lbs. (27 Nm).
WARNING:
Strictly adhere to all torque wrench tightening specifica
-
tions. Failure to do so could cause serious personal injury.
Turn the handlebars fully left and right to verify proper
operation and to make sure the throttle cable, brake hoses,
and other wires are not squeezed or pulled too tightly.
WARNING:
Failure to correctly install and verify proper operation of
the handlebars could cause a loss of control when op-
erating the dirt bike, which could result is serious injury
or death.
Lift the number plate into position. Insert tab on number
plate into hole in frame until it snaps.
Feed fuel vent line through slot in number plate into opening
in the fork frame.
FLAT
WASHER
NYLON
NUT
LOCK
WASHER
FUEL VENT
LINE
TAB
HOLE
SLOT