Baileigh JP-1250, Руководство оператора

Страница: 29 / 64

26
26
Jointer Outfeed Table Adjustment
Disconnect and lockout power to the machine! 1.
Place a straightedge upon the outfeed table near 2.
the hinged side of the table and extend it over the
cutterhead.
Rotate the cutterhead, until the knife in contact with 3.
the straight edge is at its highest point. The apex of
the knife should just barely come in contact with the
straightedge.

If the apex of the knife just makes contact with
the straightedge, no adjustment is required for
the outfeed table.

If the apex of the knife comes below the
straightedge (a gap exists) or pushes the
straightedge up, proceed with adjustment.
Loosen the lock screw (A) at the end of the 4.
adjustment knob (B).
Raise or lower the outfeed table until the straight 5.
edge just contacts the knife tip. Slightly rotate the
cutterhead to make sure the apex of the knife is just
barely contacting the straight edge.
When the table is at the correct height, hold the 6.
adjustment knob (B) in position and tighten the lock
screw (A).
Move the straight edge to the opposite side of the 7.
outfeed table and check the height at this location.
The height should be the same. If the height is
different, then adjustment is needed on the table
stop bolt (C).
Raise or lower and recheck the table to blade 8.
alignment until the entire table is exactly the same
all across the cutter head and table. Then tighten
the stop bolt jam nut to secure the bolt in position.
WARNING:
Knife inserts are dangerously sharp. Use extreme caution
when working with or around the knife inserts.
A
B
C