Baileigh IP-2511-HD, Руководство оператора

Страница: 35 / 56

32
32
ADJUST PRESSURE BAR
Distances Below Cutterhead at BDC to Pressure Bar = 0mm
To ensure accurate results and make the adjustment process quicker and easier, we
recommend using a Dial indicator for these adjustments.
Pressure Adjustment Using Dial Indicator
1. Make sure the cutterhead and table are parallel, and the cutterhead is at BDC. See
“Table
Parallelism”
as needed to measure parallelism correctly and adjust if needed.
Note : Zero the Dial indicator dial after finding the BDC of the cutterhead. This will
ensure that the following adjustments are accurate in relation to the cutterhead.
2. UNPLUG OR DISCONNECT PLANER FROM POWER
SOURCE AND LOCK OUT POWER.
3. Place the dial indicator under the right-hand side of the
pressure bar and find the BDC on the blade edge by
sliding the dial indicator right to left.
4. Adjust the height of the pressure bar on the same side as
the dial indicator to the specification given at the
beginning of this procedure, using the zero setting of the
dial indicator as a reference point. Figure 20 shows the
bolt and nut for adjusting the pressure bar height.
5. Repeat Steps 3 & 4 for the other side of the pressure bar.
Fig. 20